show mac address-table
|
Displays the MAC address table to verify all MAC addresses
on all VEMs controlled by the VSM.
See
show mac address-table.
|
show mac address-table module
module-number
|
Displays all the MAC addresses on the specified VEM.
|
show mac address-table static
HHHH.WWWW.HHHH
|
Displays the MAC address table static entries.
|
show mac address-table address
HHHH.WWWW.HHHH
|
Displays the interface on which the MAC address specified
is learned or configured.
- For dynamic MAC
addresses, if the same MAC address appears on multiple interfaces, each of them
is displayed separately.
- For static MAC
addresses, if the same MAC address appears on multiple interfaces, only the
entry on the configured interface is displayed.
See
show mac address-table address
|
show mac address-table static |
inc veth
|
Displays the static MAC address of vEthernet interfaces in
case a VEM physical port learns a dynamic MAC address and the packet source is
in another VEM on the same VSM.
See
show mac address-table static | inc veth.
|
show running-config vlan
vlan-id
|
Displays VLAN information in the running configuration.
|
show vlan [
all-ports |
brief |
id
vlan-id |
name
name |
dot1q tag native ]
|
Displays VLAN information as specified. See
show vlan.
|
show vlan summary
|
Displays a summary of VLAN information.
|
show interface brief
|
Displays a table of interface states. See
show interface brief.
|
show interface
interface_id
mac
|
Displays the MAC addresses and the burn-in MAC address for
an interface.
|
module vem
module-number
execute vemcmd show port
|
On the VEM, displays the port state on a particular VEM.
This command can only be used from the VEM.
See
module vem module-number execute vemcmd show.
|
module vem
module-number
execute vemcmd show bd
|
For the specified VEM, displays its VLANs and their port
lists.
See
module vem module-number execute vemcmd show.
|
module vem
module-number
execute vemcmd show trunk
|
For the specified VEM, displays the VLAN state on a trunk
port.
- If a VLAN is
forwarding (active) on a port, its CBL state should be 1.
- If a VLAN is
blocked, its CBL state is 0.
See
module vem module-number execute vemcmd show.
|
module vem
module-number
execute vemcmd show l2
vlan-id
|
For the specified VEM, displays the VLAN forwarding table
for a specified VLAN.
See
module vem module-number execute vemcmd show.
|