The documentation set for this product strives to use bias-free language. For the purposes of this documentation set, bias-free is defined as language that does not imply discrimination based on age, disability, gender, racial identity, ethnic identity, sexual orientation, socioeconomic status, and intersectionality. Exceptions may be present in the documentation due to language that is hardcoded in the user interfaces of the product software, language used based on RFP documentation, or language that is used by a referenced third-party product. Learn more about how Cisco is using Inclusive Language.
This chapter contains the following sections:
This section provides information about installing and configuring products that are part of the Cisco vPath Ecosystem.
To install the Cisco Nexus 1000V switch, see the instructions at the following location:
To install Cisco Prime NSC and to configure initial settings for Cisco Prime NSC, see the instructions at the following location:
To install and complete a basic configuration of Cisco VSG, see the instructions at the following location:
Cisco VSG for VMware vSphere and Cisco Prime NSC Installation and Upgrade Guide
If you deployed the Cisco ASA 1000V to use the Cisco Prime NSC management mode, see installation and configuration instructions in the Cisco ASA 1000V Getting Started Guide at the following location:
Cisco ASA 1000V Getting Started Guide
If you deployed Cisco ASA 1000V to use the ASDM management mode, see the installation and configuration instructions in the Cisco ASA 1000V Getting Started Guide at the following location:
For information related to installing and configuring Citrix NetScaler 1000V, see the relevant information at this location:
Installing and Configuring the Citrix NetScaler 1000V
Note | If the Citrix NetScaler 1000V and the Cisco ASA 1000V are in the same service chain, the Citrix NetScaler 1000V must be a VM. |
You must first install the vWAAS VM on the VMware server using vSphere before you configure vWAAS.
To install the Cisco vWAAS VM, see the installation instructions in the Cisco Wide Area Application Services vWAAS Installation and Configuration Guide at the following location:
After you install the Cisco vWAAS VM, you must configure the following vWAAS settings:
IP address and netmask
Default gateway and primary interface
Enterprise license
Central Manager address
Centralized Management System (CMS)
Interception (Web Cache Communication Protocol (WCCP) or other)
To configure these settings, see the configuration instructions in the Cisco Wide Area Application Services vWAAS Installation and Configuration Guide at the following location:
To install and configure Cisco Nexus CSP, see the workflow at the following location:
Cisco Nexus CSP Installation Workflow
To install Cisco Nexus CSP hardware, see the instructions at the following location:
Installing the Cisco Nexus Cloud Services Platform (CSP) hardware
To install Cisco Nexus CSP software, see the instructions at the following location:
Installing the Cisco Nexus Cloud Services Platform (CSP) software