A PIM Interface Was Not Created For an L3Out Interface
If a PIM interface (pim:If) is not being created for an L3Out interface, confirm the following:
- PIM is enabled on the L3Out. If PIM is disabled, enable it.
- If PIM is enabled on the container L3Out, confirm that a multicast l3ext:InstP has been created with "__int_" as a prefixed
name. This multicast l3ext:InstP is used to deploy L3Out PIM policies to the switches. There should be one multicast l3ext:InstP
- If a multicast l3ext:InstP exists on the IFC, we can check whether a corresponding fv:RtdEpP is created and deployed on each switch where there is an interface in that L3Out.
- We do not support an L3Out SVI interface for PIM.