- Cisco Connected Mobile Experiences (CMX) CVD
- CMXTOC
-
- Radio Frequency and Location Based Design
- Summary of Radio Frequency and Location Based Design
- Radio Frequency Operating and Data Rates
- Radio Frequency Fundamentals
- Antenna Fundamentals
- 802.11 Fundamentals
- Location Fundamentals
- Pre-Deployment Radio Frequency Site Survey
- Access Point Placement and Capacity Planning
- Predictive Radio Frequency Planning
- Multi-Floor Deployments
- Capacity Planning and High Density
- Location Voice and Data Co-Existence
- Post-Deployment Radio Frequency Tuning
- Best Practices Checklist
Cisco Connected Mobile Experiences (CMX) CVD
- Updated:
- December 17, 2015
Chapter: 802.11 Data Rates
802.11 Data Rates
This appendix lists data rates for 802.11an/ac rates in 5 GHz and 802.11bgn in 2.4Ghz.
IEEE 802.11a/n/ac
The channel identifiers, channel center frequencies, and regulatory domains of each IEEE 802.11a 20-MHz-wide channel are listed in Table C-1 .
|
|
|
|
|||
|---|---|---|---|---|---|
Note
All channel sets are restricted to indoor usage except the Americas (-A), which allows for indoor and outdoor use on channels 52 through 64 in the United States.
IEEE 802.11b/g/n
The channel identifiers, channel center frequencies, and regulatory domains of each IEEE 802.11b 22-MHz-wide channel are listed in Table C-2 .
|
|
|
|
||||
|---|---|---|---|---|---|---|
Note Mexico is included in the Americas regulatory domain; however channels 1 through 8 are for indoor use only while channels 9 through 11 can be used indoors and outdoors. Users are responsible for ensuring that the channel set configuration complies with the regulatory standards of Mexico.
Note France is included in the EMEA regulatory domain; however only channels 10 through 13 can be used in France. Users are responsible for ensuring that the channel set configuration complies with the regulatory standards of France.
Maximum Power Levels and Antenna Gains
IEEE 802.11a
An improper combination of power level and antenna gain can result in Effective Isotropic Radiated Power (EIRP) above the amount allowed per regulatory domain. Table C-3 indicates the maximum power levels and antenna gains allowed for each IEEE 802.11a regulatory domain.
|
|
with 6-dBi Antenna Gain |
In addition, Americas (-A) domain regulation provide different maximum power level for channels as shown in Table C-4 .
|
|
|
|---|---|
IEEE 802.11b
An improper combination of power level and antenna gain can result in EIRP above the amount allowed per regulatory domain. Table C-5 indicates the maximum power levels and antenna gains allowed for each IEEE 802.11b regulatory domain.
|
|
|
|
Feedback