Install Secure Workload Software Appliance | Deploy Secure Workload Software Appliance in VMware vSphere | Cisco Secure Workload Software Appliance Deployment Guide

The documentation set for this product strives to use bias-free language. For the purposes of this documentation set, bias-free is defined as language that does not imply discrimination based on age, disability, gender, racial identity, ethnic identity, sexual orientation, socioeconomic status, and intersectionality. Exceptions may be present in the documentation due to language that is hardcoded in the user interfaces of the product software, language used based on RFP documentation, or language that is used by a referenced third-party product. Learn more about how Cisco is using Inclusive Language.

	1.	In a browser enter the Infrastructure Management IP address using the format `https://infrastructure-manager-ipaddress/admin`. The Cisco Secure Workload Infrastructure Management Setup page appears.
	2.	From the menu, choose UI Setup.
	3.	Upload the five RPMs individually. Ensure each upload completes successfully before you proceed. Click Continue after all the RPMs are uploaded and installed.
	4.	Configure the cluster site. Enter the Site Name and SSH Public Key and click Continue. Add the Email/Username & SMTP details and click Continue. Refer to the Site Information for each of the fields in the the Advanced, Network, Service, Security, and UI tabs and fill in the required cluster information. Click Continue.
	5.	In Pre Deploy Config, the system runs a validation check. Click Continue.

Before you begin

Procedure