Modifying Network Configuration
The initial network configuration is completed using the TGSH Dialog. If you want to make changes to your initial network configuration, perform the following steps.
If you are using DHCP to obtain IPs, see the Network section.
Login to TGSH Dialog.
In the TGSH Dialog interface, choose CONFIG_NETWORK.
The Network Configuration console opens and displays the current network settings.
Make any necessary changes (you need to backspace over the old entry before you can enter the new one).
Leave the Dirty network DNS Name blank.
After you finish updating the network settings, tab down and choose Validate to verify your entries.
If errors occur, fix the invalid values and choose Validate again.
After validation, the Network Configuration Confirmation page displays the entered values
Choose Apply to apply your configuration settings.
Detailed information about the configuration changes that have been made are displayed.
The Network Configuration console refreshes again and displays the IP addresses. Network configuration is now complete.