Administrator Access Console
Enter the Cisco ISE-PIC URL in the address bar of your browser (for example, https://<ise hostname or ip address>/admin/).
Enter the username and case-sensitive password that were specified and configured during the initial Cisco ISE setup.
Click Login or press Enter.
If your login is unsuccessful, click the Problem logging in? link in the log in window and follow the instructions that are displayed.
Administrator Login Browser Support
The Cisco ISE administration portal supports the following HTTPS-enabled browsers:
Mozilla Firefox Version 61 and earlier versions
Google Chrome Version 67 and earlier versions
Administrator Lockout Due to Failed Login Attempts
If you enter an incorrect password for your specified administrator user ID enough times, the Cisco ISE administration portal locks you out of the system and adds a log entry in the Server Administrator Logins report. Cisco ISE suspends the credentials for that administrator ID until you reset the password that is associated with the administrator ID, as described in the Chapter “Performing Post-Installation Tasks”of the Cisco Identity Services Engine Hardware Installation Guide. The number of failed attempts that is required to disable the administrator account is configurable according to the guidelines that are described in Section "User Account Custom Attributes and Password Policies". After an administrator user account gets locked out, an email is sent to the associated user.
Secure SSH Key Exchange Using Diffie-Hellman Algorithm
Configure Cisco ISE-PIC to only allow Diffie-Hellman-Group14-SHA1 Secure Shell (SSH) key exchanges. Enter the following commands from the Cisco ISE-PIC CLI Configuration Mode:
service sshd key-exchange-algorithm diffie-hellman-group14-sha1
Here is an example:
ise/admin (config)#service sshd key-exchange-algorithm diffie-hellman-group14-sha1