Configure secondary IP addresses on the WAN interface and assign IP addresses to source interfaces on Cisco NFVIS.
Configure secondary IP addresses and source interfaces to enable multiple IP addresses per interface and control packet source addressing on NFVIS.
The Cisco NFVIS supports multiple IP addresses per interface. You can configure a secondary IP address on the WAN interface, as an additional IP address to reach the software. Set the external routes for secondary IP address to reach the NFVIS. Routers configured with secondary addresses can route between the different subnets attached to the same physical interface.
The Source Interface feature lets you assign an IP address to a source interface. The IP address configured is used for packets generated by the NFVIS. The packets generated use the default route.
To access secondary IP address through ISRv, the WAN physical port is removed from WAN-br similar to single IP address.
Before you begin
-
The IP address must be one of the IP addresses configured in system settings.
-
The source interface IP address can be one of the following:
-
mgmt
-
WAN
-
WAN Secondary IP
-
WAN2 IP or IP configured on any bridge
-
-
Source-interface configuration must be applied if the WAN IP is static.
-
For DHCP, source interface IP address is accepted but cannot be applied. The configuration takes effect once you switch from DHCP to static.
Procedure
| 1. | Configure Secondary IP Address: Example:
|
|
| 2. | Configure source Interface: Example:
|
The secondary IP address and source interface are configured. The secondary IP address and source interface related errors are logged in show log nfvis_config.log file.