diagnostic monitor location
To disable health-monitoring (HM) diagnostic testing for a specified location, use diagnostic monitor location command in System Admin Config mode. To enable HM testing (default condition), use the no form of this command.
diagnostic monitor location node-name test test-name disable
no diagnostic monitor location node-name test test-name disable
Syntax Description
node-name |
Location where diagnostic monitoring has to disabled/enabled. |
test-name |
Name of the diagnostic test. Currently, only filesystem_test is supported. You can use show diagnostic content command in System Admin EXEC mode to see a list of test names and other associated attributes. |
disable |
Disables diagnostic monitoring for a specified location. |
Command Default
By default, the health-monitoring tests are enabled in the system.
Command Modes
System Admin Config
Command History
Release |
Modification |
---|---|
Release 6.3.1 |
This command was introduced. |
Examples
This example shows how to enable health-monitoring diagnostic testing for 0/7:
sysadmin-vm:0_RP0(config)# diagnostic monitor location 0/7 test filesystem_test disable