overlap-tap enable
To configure traffic interception separately for two inter-communicating intercepted hosts, use the overlap-tap enable command in XR Config mode. To revert to the default configuration, use the no form of this command.
overlap-tap enable
Syntax Description
This command has no keywords or arguments.
Command Default
For two inter-communicating hosts where both the hosts are separately intercepted, only the ingress traffic on the ASR 9000 router related to one of the hosts is intercepted.
Command Modes
XR Config modeCommand History
Release | Modification |
---|---|
Release 5.3.2 |
This command was introduced. |
Usage Guidelines
To use overlap-tap enable command, you must have lawful intercept configured by installing and activating asr9k-li-px.pie.
Task ID
Task ID | Operation |
---|---|
li |
read |
Example
The following example shows how to configure interception of both the ingress and egress traffic on the ASR 9000 router related to two inter-communicating hosts.
RP/0/RP0/CPU0:router# configure
RP/0/RP0/CPU0:router(config)# overlap-tap enable