Before deploying your router you should determine that the feature profile is consistent with the features that you need to
use. If it is not, use this task to configure a different profile.
If you see warning messages to the console indicating that the active feature profile does not match the configured profile,
you must reload the affected line card so that the configured profile matches the active profile.
LC/0/1/CPU0:Nov 5 02:50:42.732 : prm_server: Configured 'hw-module
profile feature l2' does not match active 'hw-module profile feature default'.
You must reload this line card in order to activate the configured profile on
this card or you must change the configured profile.
If you see warning messages to the console indicating that some features do not match the feature profile, you should either
change the feature profile configuration, or remove the non-supported features.
LC/0/1/CPU0:Nov 5 02:50:42.732 : prm_server: Active 'hw-module profile
feature l2' does not support IPv6, RPF, or Netflow features. Please remove all
unsupported feature configurations.
*"hw-module profile feature" syntax only applies to Trident based line cards;
therefore the limitations of IPv6, reverse-path forwarding (RPF) and Netflow do
not apply to either Tomahawk or Typhoon based line cards.