The documentation set for this product strives to use bias-free language. For the purposes of this documentation set, bias-free is defined as language that does not imply discrimination based on age, disability, gender, racial identity, ethnic identity, sexual orientation, socioeconomic status, and intersectionality. Exceptions may be present in the documentation due to language that is hardcoded in the user interfaces of the product software, language used based on RFP documentation, or language that is used by a referenced third-party product. Learn more about how Cisco is using Inclusive Language.
This document describes installing and replacing CompactFlash memory cards in Cisco IAD2801 series integrated access devices. It contains the following sections:
•Preventing Electrostatic Discharge Damage
•Removing a CompactFlash Memory Card
•Installing a CompactFlash Memory Card
CompactFlash memory cards are sensitive to electrostatic discharge (ESD) damage, which can occur when electronic cards or components are handled improperly, results in complete or intermittent failures.
To prevent ESD damage, follow these guidelines:
•Always use an ESD wrist or ankle strap and ensure that it makes good skin contact.
•Connect the equipment end of the strap to an unfinished chassis surface.
•Place a removed CompactFlash memory card on an antistatic surface or in a static shielding bag. If the card will be returned to the factory, immediately place it in a static shielding bag.
•Avoid contact between the card and clothing. The wrist strap protects the card from ESD voltages on the body only; ESD voltages on clothing can still cause damage.
•Do not remove the wrist strap until the installation is complete.
To remove a CompactFlash memory card from the chassis, perform the following steps:
Step 1 Press the ejector button next to the CompactFlash memory card. The ejector button moves outward so that it projects from the panel.
Step 2 Press the ejector button again. This ejects the CompactFlash memory card part-way out of its slot.
Step 3 Pull the CompactFlash memory card out of its slot.
Step 4 Push the ejector button in until the button is flush with the bezel.
To install a CompactFlash memory card, perform the following steps:
Step 1 Make sure that the ejector button is fully seated so that it does not project out from the panel.
Note If the ejector button is projecting out from the panel, push it in until it is flush with the bezel.
Step 2 Insert the CompactFlash memory card into the slot until it is fully seated. The ejector button remains flush with the panel.
Note If the ejector button is projecting from the panel after you insert the CompactFlash memory card, remove the CompactFlash memory card, press the ejector button until it clicks, and reinsert the CompactFlash memory card.