The documentation set for this product strives to use bias-free language. For the purposes of this documentation set, bias-free is defined as language that does not imply discrimination based on age, disability, gender, racial identity, ethnic identity, sexual orientation, socioeconomic status, and intersectionality. Exceptions may be present in the documentation due to language that is hardcoded in the user interfaces of the product software, language used based on RFP documentation, or language that is used by a referenced third-party product. Learn more about how Cisco is using Inclusive Language.
Performance monitoring (PM) parameters are used by service providers to gather, store, set thresholds for, and report performance data for early detection of problems. The user can retrieve both current and historical PM counters for the various controllers in 15 minutes and 1 day intervals.
PM for optical parameters include laser bias current, transmit and receive optical power, mean polarization mode dispersion, accumulated chromatic dispersion, and received optical signal-to-noise ratio (OSNR). These parameters simplify troubleshooting operations and enhance data that can be collected directly from the equipment.
For descriptions of optics, Ethernet, fec, and otn parameters, see the Command Reference for Cisco NCS 1000 Series.
You can configure the performance monitoring parameters for the Optics, Ethernet, and coherent DSP controllers. The coherent DSP controller is created on the trunk port when the slice is provisioned using the hw-module command. To configure PM parameters, use the following commands.
configure
controller controllertype R/S/I/P { pm { 15-min | 30-sec | 24-hour } { optics | ether | fec | otn } { report | threshold } value }
commit
The following is a sample in which the performance monitoring parameters of Optics controller is configured in 24 hour intervals.
configure controller optics 0/0/0/0 pm 24-hour optics report cd max-tca enable commit
The following is a sample in which the performance monitoring parameters of Ethernet controller is configured in 15 minute intervals.
configure controller HundredGigECtrlr 0/0/0/1 pm 15-min ether report 1024-1518-octets enable commit
The following is a sample in which the performance monitoring parameters of Coherent DSP controller is configured in 15 minute intervals.
configure controller coherentDSP 0/0/0/12 pm 15-min otn threshold es-ne commit
Use this procedure to view the performance monitoring parameters for Optics, Ethernet, and coherent DSP controllers.
Associated Commands