Understanding the Carrier Packet Transport System
|
Provides an overview of the Carrier Packet Transport (CPT) system and information about the CPT cards, CPT software features, and CPT configuration modes.
|
Hardware
|
Describes the fabric card, line card, and CPT 50 panel. It also explains how to install the cards and the CPT 50 shelf.
|
Configuring Ethernet Virtual Circuit
|
Describes Ethernet Virtual Circuit (EVC), EVC types, Ethernet Flow Point (EFP), and bridge domain. This chapter also describes procedures to configure EVC and EFP.
|
Configuring Multiprotocol Label Switching
|
Describes Multiprotocol Label Switching and procedures to configure Multiprotocol Label Switching.
|
Configuring Multiprotocol Label Switching
|
Describes the Multiprotocol Label Switching–Transport Profile and procedures to configure Multiprotocol Label Switching–Transport Profile.
|
Configuring Pseudowire
|
Describes static and dynamic pseudowires. This chapter also describes the configuration procedures of pseudowires.
|
Configuring Virtual Private LAN Services |
Describes Virtual Private LAN Services (VPLS) and procedures to configure VPLS.
|
Configuring Quality of Service
|
Describes the Quality of Service and procedures to configure Quality of Service. |
Configuring High Availability
|
Describes Stateful Switchover, Cisco Nonstop Forwarding, and In-Service Software Upgrade. This chapter also describes the configuration procedures.
|
Configuring Resilient Ethernet Protocol |
Describes Resilient Ethernet Protocol (REP), REP configuration guidelines, VLAN load balancing, REP timers, and REP over EVC. This chapter also describes procedures to configure REP. |
Configuring Link Aggregation Group and Link Aggregation Control Protocol |
Describes Link Aggregation Group and Link Aggregation Control Protocol and the configuration procedures. |
Configuring Span |
Describes port and EFP span and the configuration procedures. |
Configuring MAC Learning |
Describes MAC learning and procedures to configure MAC learning. |
Configuring Multicast VLAN Registration |
Describes Multicast VLAN Registration and procedures to configure Multicast VLAN Registration. |
Configuring IGMP Snooping |
Describes IGMP Snooping and procedures to configure IGMP Snooping. |
Configuring Ethernet OAM, Connectivity Fault Management, and Y.1731 |
Describes Ethernet OAM, Connectivity Fault Management (CFM), and Y.1731 and procedures to configure Ethernet OAM, CFM, and Y.1731. |
Configuring Synchronous Ethernet |
Describes Synchronous Ethernet and procedures to configure Synchronous Ethernet. |
Configuring Performance Monitoring, RMON, OTN, and Port Provisioning |
Describes performance monitoring, Remote Monitoring, and Optical Transport Network and the configuration procedures. |
Configuring Local Authentication |
Describes local authentication and procedures to configure local authentication. |
Configuring Cisco Discovery Protocol |
Describes Cisco Discovery Protocol (CDP) and procedures to configure CDP. |
Alarm Troubleshooting |
Describes CPT alarms. |
SNMP |
Describes SNMP and the MIBs supported in CPT. |
CPT Error Messages |
Describes the CPT error messages. |
Support for MSTP Cards |
Lists the MSTP cards supported in the CPT 200 and CPT 600 chassis. |
Network Element Defaults |
Describes the Network Element (NE) defaults supported on CPT 200 and CPT 600. |