RMV Commands
This chapter provides RMV (remove) commands for the Cisco ONS 15454 SDH.
19.1 RMV-<MOD2>
Remove (10GFC, 10GIGE, 1GFC, 1GFICON, 2GFC, 2GFICON, CLNT, D1VIDEO, DS3I, DV6000, E1, E3, E4, ESCON, ETRCLO, FSTE, G1000, GFPOS, GIGE, HDTV, ISC1, STM4, STM64, STM1, STM16, OCH, OMS, OTS, POS, STM1E, VC3, VC44C, VC38C, VC464C, VC48C, STS36C, VC4, VC416C, VC42C, VC43C, VC12)
Usage Guidelines
This command removes a facility from service.
See Table 27-1 for supported modifiers by platform.
Category
Ports
Security
Maintenance
Input Format
RMV-<MOD2>:[<TID>]:<AID>:<CTAG>[::];
Input Example
RMV-E1:CISCO:FAC-1-1:1;
Input Parameters
Table 19-1 RMV-<MOD2> Input Parameters
|
|
AID |
Access identifier from the "ALL" section |
19.2 RMV-EQPT
Remove Equipment
Usage Guidelines
This command removes equipment from the In Service state and places it into the Maintenance state.
Note
Only applicable to equipment that is in transition from the In-Service state to the Maintenance state.
Category
Equipment
Security
Maintenance
Input Format
RMV-EQPT:[<TID>]:<AID>:<CTAG>[::];
Input Example
RMV-EQPT:CISCO:SLOT-1:1;
Input Parameters
Table 19-2 RMV-EQPT Input Parameters
|
|
AID |
Access identifier from the "EQPT" section |