Cisco Virtual Topology System (VTS) 2.4.2 Installation Guide

Bias-Free Language

The documentation set for this product strives to use bias-free language. For the purposes of this documentation set, bias-free is defined as language that does not imply discrimination based on age, disability, gender, racial identity, ethnic identity, sexual orientation, socioeconomic status, and intersectionality. Exceptions may be present in the documentation due to language that is hardcoded in the user interfaces of the product software, language used based on RFP documentation, or language that is used by a referenced third-party product. Learn more about how Cisco is using Inclusive Language.

Book Contents

Find Matches in This Book

Results

Updated:: February 17, 2017

Chapter: Introduction

Introduction

The Cisco Virtual Topology System (VTS) is a standards-based, open, overlay management and provisioning system for data center networks.

This document describes how to install the different components of Cisco Virtual Topology System (VTS).

For information about installing Cisco VTS on an OpenStack environment, see Installing Cisco VTS in a Linux - OpenStack Environment.
For information about installing Cisco VTS on a VMware ESXi environment, see Installing Cisco VTS on a VMware Environment.

For information about the prerequisites to install Cisco VTS, see Prerequisites.

For information about installing Cisco VTS in High Availability mode, see Installing VTS in High Availability Mode

You can also install Cisco VTS without a Virtual Machine Manager (VMM). See the Cisco VTS Developer Guide for details.

For more information about Cisco VTS, see the product documentation available on Cisco.com.

Was this Document Helpful?

Feedback

Contact Cisco

Open a Support Case
(Requires a Cisco Service Contract)