Configure SNMP Credentials for Rogue AP Tracing
The SNMP Credentials page allows you to specify credentials to use for tracing rogue access points. Use this option when you cannot find a specific entry using a number-based entry. When a switch credential is not added to Cisco Prime Infrastructure, you can use SNMP credentials on this page to connect to the switch.
Procedure
Step 1 |
Choose , then choose . The Manual SPT page appears. |
Step 2 |
View or edit the details for a current SNMP credential entry by clicking the Network Address link for that entry. For details on this task, see “Configure Global SNMP Settings” and “View SNMP Credential Details” in related topics. Note that the default entry is for network 0.0.0.0, which indicates the entire network. SNMP credentials are defined per network, so only network addresses are allowed. The SNMP credentials defined for network 0.0.0.0 is the SNMP credential default. It is used when no specific SNMP credential is defined. You should update the pre-populated SNMP credential with your own SNMP information. |
Step 3 |
To add a new SNMP entry, choose Select a command > Add SNMP Entries > Go (see “Add SNMP Credentials”). |