Cisco Elastic Services Controller 5.4 Administration Guide

Bias-Free Language

The documentation set for this product strives to use bias-free language. For the purposes of this documentation set, bias-free is defined as language that does not imply discrimination based on age, disability, gender, racial identity, ethnic identity, sexual orientation, socioeconomic status, and intersectionality. Exceptions may be present in the documentation due to language that is hardcoded in the user interfaces of the product software, language used based on RFP documentation, or language that is used by a referenced third-party product. Learn more about how Cisco is using Inclusive Language.

Book Contents
Find Matches in This Book
Available Languages
Download Options

Book Title

Cisco Elastic Services Controller 5.4 Administration Guide

Chapter Title

Before Contacting Tech Support

Results

Updated:
February 5, 2021

Chapter: Before Contacting Tech Support

Before Contacting Tech Support

At some point, you might need to contact your technical support representative or Cisco TAC for some additional assistance. This section outlines the steps that you should perform before you contact your next level of support in order to reduce the amount of time spent resolving the issue.

Downloading Logs from the ESC

You can download log files from the ESC for troubleshooting.

To collect log files through CLI, use the following command:
sudo escadm log collect
To collect configuration data for VMs, use the following command,
esc_nc_cli --user <username> --password <password> get-config esc_datamodel > <file-name>
For example:
esc_nc_cli --user <username> --password <password> get-config esc_datamodel > /var/tmp/esc_datamodel.txt
To collect log files through CLI from ESC Active/Active HA, use the following command:
esc_nc_cli --host db.service.consul --user admin --password password get-config esc_datamodel

For more information of the ESC system level configuration, see Downloading Logs from the ESC Portal section in the Cisco Elastic Services Controller User Guide.

Things To Do Before Calling TAC

Answer the following questions before you contact your technical support representative:

  1. Collect the system information and configuration through CLI (system log files) and through GUI. For instructions, refer Downloading the log files.

  2. If an error occurs in ESC, take a screen shot of the error. In Windows, press Alt+PrintScreento capture the active window, or press PrintScreen to capture the entire desktop. Paste the screenshot into a new Microsoft Paint (or similar program) session and save the file.

  3. Capture the exact error codes that you see in the message logs from either ESC or the CLI.

  4. Answer the following questions before you contact your technical support representative:

    • Which ESC version, operating systems versions, and storage device firmware are in your network?

    • Were any changes made to the environment (VLANs, upgrades, or adding modules) prior to or at the time of this event?

    • Are there other similarly configured devices that could have this problem but do not?

    • Where was this problematic device connected (which device and interface)?
    • When did this problem first occur?
    • When did this problem last occur?
    • How often does this problem occur?
    • Were any traces or debug output captured during the problem time?
    • What troubleshooting steps have you attempted?
  5. Answer the following questions if your problem is related to a software upgrade attempt:

    • What was the original Cisco ESC version?

    • What is the new Cisco ESC version?

    • Collect the output from the following command and forward them to your customer support representative: 

      • esc_nc_cli --user <username> --password <password> get-config esc_datamodel > <file-name>
      • esc_version
      • health.sh
      • escadm status
      • escadm vim show

Was this Document Helpful?

FeedbackFeedback

Contact Cisco