Introduction to the Cisco Broadband Access Center CLI
This chapter describes how you can start the command line interface (CLI) to access the Cisco Broadband Access Center (Cisco BAC) Device Provisioning Engine (DPE).
Accessing the DPE CLI from a Local Host
To access the DPE CLI, open a Telnet session to port 2323 from a local or remote host.
To access the CLI from a local host, you can enter:
Accessing the DPE CLI from a Remote Host
To access the CLI from a remote host, enter:
# telnet remote-hostname 2323
Note If you cannot establish a Telnet connection to the CLI, it is likely that the CLI server is not running. You may need to start the server. To start the server, enter:
# /etc/init.d/bprAgent start cli
After you access the CLI, you must enter the DPE password to continue. The default login and enable passwords are changeme. The CLI prompts you to enter a new login/enable password and confirm. The CLI accepts any password other than an empty password.
For information on how to change the login password and the enable password, see the password, and the enable password, commands, respectively.
Escape character is '^]'.
bac_host BAC Device Provisioning Engine