Cisco Broadband Access Center DPE CLI Guide 3.8
Bias-Free Language
The documentation set for this product strives to use bias-free language. For the purposes of this documentation set, bias-free is defined as language that does not imply discrimination based on age, disability, gender, racial identity, ethnic identity, sexual orientation, socioeconomic status, and intersectionality. Exceptions may be present in the documentation due to language that is hardcoded in the user interfaces of the product software, language used based on RFP documentation, or language that is used by a referenced third-party product. Learn more about how Cisco is using Inclusive Language.
- Updated:
- March 5, 2012
Chapter: Auth Service Configuration Commands
Auth Service Configuration Commands
This chapter describes the command line interface (CLI) commands that you can use to configure various settings for the auth service running on the Cisco Broadband Access Center (Cisco BAC) Device Provisioning Engine (DPE).
This is the global syntax of the commands that you can use to configure various settings for the auth service running on the DPE. Using these commands, you can:
•
Enable the auth service
•Set the host address for the service
• Set the port number for the service
• Configure the service to use HTTP over SSL/TLS
.
|
|
|
|
|---|---|---|
service auth num enable {true | false} |
||
Enables or disables the auth service running on the DPE. |
num—Identifies the auth service, which is always 1. By default, the auth service is enabled. • • |
dpe# service auth 1 enabled true % OK (Requires DPE restart "# dpe reload") |
service auth num address address |
||
Sets the host address for the auth service running on the DPE. |
num—Identifies the auth service, which is always 1. address—Identifies the host address for the auth service running on the DPE. By default, the host address for the auth service running on the DPE is 127.0.0.1. |
dpe# service auth 1 host address 127.0.0.1 % OK (Requires DPE restart "# dpe reload") |
|
||
Identifies the port on which the auth service communicates with the Cisco Access Registrar Extension Points. By specifying a different port number, this command enables the DPE to prevent potential sharing violations among ports used by other applications. |
• • By default, the auth service is configured to listen on Port 7551. |
dpe# service auth 1 port 7551 % OK (Requires DPE restart "# dpe reload") |
service auth num ssl enabled {true | false} |
||
Enables or disables the use of HTTP over SSL/TLS for the auth service on the DPE. The auth service will not start up if you do not configure the keystore file and the keystore passwords before restarting the DPE. For information on how to configure a keystore file and keystore passwords, see the Cisco Broadband Access Center 3.8 Administrator Guide. |
• • • |
dpe# service auth 1 ssl enabled true % OK (Requires DPE restart "# dpe reload") |
Feedback