The documentation set for this product strives to use bias-free language. For the purposes of this documentation set, bias-free is defined as language that does not imply discrimination based on age, disability, gender, racial identity, ethnic identity, sexual orientation, socioeconomic status, and intersectionality. Exceptions may be present in the documentation due to language that is hardcoded in the user interfaces of the product software, language used based on RFP documentation, or language that is used by a referenced third-party product. Learn more about how Cisco is using Inclusive Language.
This chapter describes the command line interface (CLI) commands that you can use to debug the CWMP technology on the Cisco Broadband Access Center (Cisco BAC) Device Provisioning Engine (DPE).
Note Before using any debug command, ensure that DPE debugging is enabled. Run the debug on command to enable this function. See debug on for more information.
The different commands explained in this chapter are:
•debug service auth num client-auth-all
•debug service auth num client-auth-failures
•no debug service auth num details
•debug service auth num errors
•no debug service auth num faults
•debug service auth num headers
This section describes the commands that you use to debug the auth service that runs on the DPE.