Voice systems that pass digitized pulse-code modulation (PCM) speech have always relied on the clocking signal being embedded in the received bit stream. This technique allows connected devices to recover the clock signal from the bit stream, and then use this recovered clock signal to ensure that data on different channels keeps the same timing relationship with other channels.
If a common clock source is not used between devices, the binary values in the bit streams may be misinterpreted because the device samples the signal at the wrong moment. As an example, if the local timing of a receiving device is using a slightly shorter time period than the timing of the sending device, a string of eight continuous binary 1s may be interpreted as nine continuous 1s. If this data is then resent to further downstream devices that use varying timing references, the error can be compounded. When you make sure that each device in the network uses the same clocking signal, the integrity of the traffic can be trusted.
If timing between devices is not maintained, a condition known as clock slip can occur. Clock slip is the repetition or deletion of a block of bits in a synchronous bit stream due to a discrepancy in the read and write rates at a buffer.
Slips are caused by the inability of an equipment buffer store (or other mechanisms) to accommodate differences between the phases or frequencies of the incoming and outgoing signals in cases where the timing of the outgoing signal is not derived from that of the incoming signal.
A BRI interface sends traffic inside repeating bit patterns called frames. Each frame is a fixed number of bits. This means that the receiving device knows exactly when to expect the end of a frame simply by counting the bits as they arrive. Therefore, if the timing between the sending and receiving device is not the same, the receiving device may sample the bit stream at the wrong moment, resulting in an incorrect value being returned.
Even though you can configure Cisco IOS software to control the clocking on these devices, the default clocking mode is effectively free running, meaning that the received clock signal from an interface is not connected to the backplane of the router and used for internal synchronization between the rest of the router and its interfaces. The router uses its internal clock source to pass traffic across the backplane and other interfaces.
For data applications, this internal clock sourcing generally does not present a problem because a packet is buffered in internal memory and is then copied to the transmit buffer of the destination interface. The reading and writing of packets to memory effectively removes the need for any clock synchronization between ports.
Digital voice ports have a different issue. Unless otherwise configured, Cisco IOS software uses the backplane (or internal) clocking to control the reading and writing of data to the DSPs. If a PCM stream comes in on a digital voice port, it uses the external clocking for the received bit stream. However, this bit stream is not necessarily using the same reference as the router backplane, meaning the DSPs can misinterpret the data that is coming in from the controller.
This clocking mismatch is seen on the router's BRI controller as a clock slip--the router is using its internal clock source to send the traffic out the interface but the traffic coming in to the interface is using a completely different clock reference. Eventually, the difference in the timing relationship between the transmit and receive signal becomes so great that the controller registers a slip in the received frame.
To eliminate the problem, you must change the default clocking behavior through Cisco IOS configuration commands. It is absolutely critical to set up the clocking commands properly.
Even though the following commands are optional, we strongly recommend that you enter them as part of your configuration that you ensure proper network clock synchronization:
network-clock-participate slot slot-number
network-clock-select priority bri t1 e1 } slot/port
The network-clock-participate command allows the router to use the clock from the line via the specified slot and synchronize the onboard clock to the same reference.
If multiple VWICS are installed, you must repeat the commands for each installed card. The system clocking can be confirmed using the show network clocks command.