Catalyst 6500 Series Switch and Cisco 7600 Series Router Network Analysis Module Release 3.4 Configuration Note
Bias-Free Language
The documentation set for this product strives to use bias-free language. For the purposes of this documentation set, bias-free is defined as language that does not imply discrimination based on age, disability, gender, racial identity, ethnic identity, sexual orientation, socioeconomic status, and intersectionality. Exceptions may be present in the documentation due to language that is hardcoded in the user interfaces of the product software, language used based on RFP documentation, or language that is used by a referenced third-party product. Learn more about how Cisco is using Inclusive Language.
- Updated:
- March 22, 2005
Chapter: Installing the NAM
Requirements for the Network Analysis Module
This chapter describes the software and hardware requirements to support the Catalyst 6500 series switch, Catalyst 6000 series switch, or Cisco 7600 series router NAM. This chapter contains these sections:
Software Requirements
Note 
Starting with maintenance image release 2.1(1), there is a single maintenance image for services modules. Refer to this URL:
http://www.cisco.com/cgi-bin/tablebuild.pl/cat6000-serv-maint
Table 2-1 lists the NAM software releases that are supported by Catalyst operating system software and Cisco IOS software.
|
|
|
|
|
|
|
|
|---|---|---|---|---|---|---|
WS-SVC-NAM-1 |
3.4(1) |
1.1(1)m 2.1(1) |
Release 7.3(1) or later with Supervisor Engine 1A or 22 Release 8.5(1) or later. |
Release 12.1(13)E3 or later with a Supervisor Engine 2 with an MSFC2 Release 12.1(19)E1 or later with a Supervisor Engine 1A with an MSFC2 Release 12.2(14)SX1 with a WS-SUP720 |
Recommended — Internet Explorer 6.0 and later on Windows 2000 Netscape 7.0 or 7.1 on Windows 2000 and Solaris |
1.3.1_03 or 1.4.1_02 |
1 Traffic Analyzer does not require a Java plug-in although a plug-in might be required to use Java Virtual Machine (JVM). The Java plug-in versions listed have been tested for browsers that require a plug-in for JVM. 2 Supervisor 1A with MSFC1 or MSFC2, Supervisor 2 with MSFC2 only. 3 If you are using a 12.1(13)E-based release, we recommend that you use a later 13E release, for example, Release 12.1(13)E11 over 12.1(13)E3. |
Hardware Requirements
Table 2-2 lists the NAM hardware releases that are supported by Catalyst operating system software and Cisco IOS software.
Feedback