Cisco APIC Layer 3 Networking Configuration Guide, Release 6.2(x)

PDF

Cisco APIC Layer 3 Networking Configuration Guide, Release 6.2(x)

Configure Dataplane IP Address Learning per Subnet Using the GUI

Updated: April 17, 2026

Want to summarize with AI?

Log in

Configures dataplane IP address learning for a specific subnet within the GUI. This feature is enabled by default for all subnets.

The following procedure enables or disables dataplane IP address learning for a subnet.

Procedure

1.

On the menu bar, choose Tenants > All Tenants .

2.

In the Work pane, double-click the tenant's name.
3.

If you are modifying an existing subnet, perform the following substeps:

  1. In the Navigation pane, choose Tenant tenant_name > Networking > Bridge Domains > bridge_domain_name > Subnets > subnet_address .

    If you want to disable dataplane IP address learning, there must not be a check in the No Default SVI Gateway checkbox.

  2. In the Work pane, for the IP Data-plane Learning toggle, choose Enable or Disable , as desired.

    This enables or disables IP address dataplane learning for the subnet.
4.

If you are creating a new subnet, perform the following substeps:

  1. In the Navigation pane, choose Tenant tenant_name > Networking > Bridge Domains > bridge_domain_name > Subnets .

  2. Right click Subnets and choose Create Subnet .

  3. For the Default Gateway IP field, enter the IP address and mask.

  4. If you want to disable dataplane IP address learning, do not put a check in the No Default SVI Gateway checkbox.

  5. For the IP Data-plane Learning toggle, choose Enable or Disable , as desired.

    This enables or disables IP address dataplane learning for the subnet.

  6. Fill out the remaining fields as necessary.
5.

Click Submit .