Customize your topology map display | Topology Map for Network Visualisation | Cisco Crosswork Network Controller 7.2.x Administration Guide

The documentation set for this product strives to use bias-free language. For the purposes of this documentation set, bias-free is defined as language that does not imply discrimination based on age, disability, gender, racial identity, ethnic identity, sexual orientation, socioeconomic status, and intersectionality. Exceptions may be present in the documentation due to language that is hardcoded in the user interfaces of the product software, language used based on RFP documentation, or language that is used by a referenced third-party product. Learn more about how Cisco is using Inclusive Language.

	1.	From the main menu, click Topology.
	2.	On the topology map, open the Display preferences dialog box.
	3.	In the Devices tab: Show or hide device state. Select your preferred label type, such as host name, IP address, or OSPF Router ID.
	4.	In the Links tab: Toggle the option to distinguish aggregated links from single links. Note Aggregated dual stack links are displayed as a single line. Choose the link color scheme based on down state or utilization. If you select utilization, set the appropriate thresholds.
	5.	In the Alarms tab: Show or hide device-level alarms. Filter alarms by severity to display only those at or above your chosen threshold.

Before you begin

Procedure