RPD Reset

Your software release may not support all the features that are documented in this module. For the latest feature information and caveats, see the release notes for your platform and software release. The Feature Information Table at the end of this document provides information about the documented features and lists the releases in which each feature is supported.

Hardware Compatibility Matrix for Cisco Remote PHY Device


Note

Unless otherwise specified, the hardware components introduced in a given Cisco Remote PHY Device Software Release are supported in all subsequent releases.

Table 1. Hardware Compatibility Matrix for the Cisco 2x2 Remote PHY Device

Cisco HFC Platform

Remote PHY Device

Cisco GS7000 BAU

Cisco 2x2 RPD Software 2.x and Later Releases

Cisco Remote PHY Device 2x2

PID—RPD-2X2=

Information about RPD Reset

Starting from Cisco 2x2 RPD Software x.x, factory reset and NVRAM reset via TLV and CLI are supported. In the factory reset, RPD restores the factory configuration and performs cold reboot. In this case, it is better for the RPD to have golden image, otherwise users need to boot the RPD manually. In the NVRAM reset, RPD clears the non-volatile configuration and performs cold reboot.

Resetting RPD

To clear the configuration, image and logs of the RPD, perform factory reset as shown in the following example:

R-PHY#reboot factory-reset
Warning: This action will restore the factory configuration. Are you sure you want to do the factory reset (yes/no)?

To clear the non-volatile configuration of the RPD, perform NVRAM reset as shown in the following example:

R-PHY#reboot nv-reset
Warning: This action will clear the non-volatile configuration. Are you sure you want to do the nvreset (yes/no)?

Feature Information for RPD Reset


Note

The following table lists the software release in which a given feature is introduced. Unless noted otherwise, subsequent releases of that software release train also support that feature.

Table 2. Feature Information for RPD Reset

Feature Name

Releases

Feature Information

Factory reset support

Cisco 2x2 RPD Software 2.x

This feature was introduced on the Cisco 2x2 Remote PHY Device.