Powering Up the Cisco cBR Chassis

Powering Up the Cisco cBR

Before You Begin
After all the interfaces and other cables are connected, perform a visual check of all connections and check that:

  • The ejector levers on each line card are in the locked position.

  • All the top and bottom line card captive screws are tight.

  • All network interface cables are connected.

  • The console terminal is turned on.

    Step 1   Make sure the chassis ground connection is attached.
    Step 2   Push the toggle switch on the FPIM (AC or DC) on the rear of the chassis to ON position.
    What to Do Next

    Ensure the POWER ENABLE LED on the FPIM illuminates green.

    Verify if the LEDs on the Power Module indicate input voltage presence within correct range.