Video QAM Carriers

For video provisioning, the carriers must be of type “video” in the controller integrated-cable configuration.

Contents

Configuring the Video QAM Carriers

To configure the Video QAM carriers, complete the following procedure: 

configure terminal
controller integrated-cable slot/bay/port
rf-channel start-channel – end-channel
type video
start-frequency frequency
rf-output normal
power-adjust number
qam-profile qam-profile number

Configuration Examples

This section provides configuration examples for the QAM video carrier.

Video QAM Carriers

The following is a sample for the Video QAM carrier configuration: 

configure terminal
 controller integrated-cable 7/1/0
         rf-channel 1-3
             type video
             start-frequency 93000000
             rf-output normal
             power-adjust 0
             qam-profile 1

Feature Information for QAM Video Carriers

Use Cisco Feature Navigator to find information about platform support and software image support. Cisco Feature Navigator enables you to determine which software images support a specific software release, feature set, or platform. To access Cisco Feature Navigator, go to http:/​/​www.cisco.com/​go/​cfn. An account on Cisco.com is not required.


Note

The table below lists only the software release that introduced support for a given feature in a given software release train. Unless noted otherwise, subsequent releases of that software release train also support that feature.

Table 1 Feature Information for QAM Video Carriers

Feature Name

Releases

Feature Information

QAM Video Carriers

Cisco IOS XE Everest 16.6.1

This feature was integrated on the Cisco cBR Series Converged Broadband Routers.