You can perform some global configurations for provisioning the video services. These configurations have some default values. If you do not choose to change those values, the default values are used. The following sections describe the procedures for global configurations.
By default, the system ONID is 0, which is commonly used in North America. If the default value of the ONID is used, the TSID must be unique. You can change the default ONID. If you change the ONID, the TSID-ONID pair must be unique. The ONID must be in the range of 0 to 65535.
configure terminal cable video default-onid default onid number
By default, the Program Specific Information (PSI) interval is 100 msec. You can change the default PSI interval. The PSI interval must be in the range of 40 to 1000.
configure terminal cable video default-psi-intervaldefault-psi-interval msec
configure terminal cable video timeout init-session timeout msec timeout idle-session timeout msec timeout off-session timeout sec
This section provides examples for the global video configuration.
configure terminal cable video default-onid 10 default- psi-interval 50 timeout init-session 200 msec timeout idle-session 250 msec timeout off-session 500 sec
The following table provides release information about the feature or features described in this module. This table lists only the software release that introduced support for a given feature in a given software release train. Unless noted otherwise, subsequent releases of that software release train also support that feature.
Use Cisco Feature Navigator to find information about platform support and Cisco software image support. To access Cisco Feature Navigator, go to www.cisco.com/go/cfn. An account on Cisco.com is not required.|
Feature Name |
Releases |
Feature Information |
|---|---|---|
|
Global Video Configuration |
Cisco IOS XE Everest 16.6.1 |
This feature was integrated on the Cisco cBR Series Converged Broadband Routers. |
Feedback