The reserved output PID range allows the user to specify a range of PIDs that will not be used as output for remapped sessions. A range of up to 4000 PIDs from 1-8190 can be reserved.

One continuous reserved PID range is supported for each chassis. Note that the protection is only good for future output remapped PIDs, so the reserved PID range is expected to be configured before any remapped sessions are created. Remapped PIDs within the reserved range that already exists will not be reallocated.

To configure reserved output range, follow the steps below:

enable 
configure terminal 
cable video 
reserve-pid-range start-pid-end-pid 

To verify the reserved output PID range configuration, use the show cable video logical-edge-device id id reserve-pid-range command as shown in the example below.

Router# show cable video logical-edge-device id 1 reserve-pid-range
Logical Edge Device: led1
Id: 1
Reserve PID Range: 1-4000