Video QAM Carriers

For video provisioning, the carriers must be of type “video” in the controller integrated-cable configuration.

Contents

Configuring the Video QAM Carriers

To configure the Video QAM carriers, complete the following procedure:

configure terminal 
controller integrated-cable slot/bay/port 
rf-channel start-channelend-channel 
type video 
start-frequency frequency 
rf-output normal 
power-adjust number 
qam-profile qam-profile number 

Configuration Examples

This section provides configuration examples for the QAM video carrier.

Video QAM Carriers

The following is a sample for the Video QAM carrier configuration:

configure terminal 
 controller integrated-cable 7/1/0 
         rf-channel 1-3 
             type video 
             start-frequency 93000000 
             rf-output normal 
             power-adjust 0 
             qam-profile 1 

Feature Information for QAM Video Carriers

Use Cisco Feature Navigator to find information about the platform support and software image support. Cisco Feature Navigator enables you to determine which software images support a specific software release, feature set, or platform. To access Cisco Feature Navigator, go to the www.cisco.com/go/cfn link. An account on the Cisco.com page is not required.


Note

The following table lists the software release in which a given feature is introduced. Unless noted otherwise, subsequent releases of that software release train also support that feature.


Table 1. Feature Information for QAM Video Carriers

Feature Name

Releases

Feature Information

QAM Video Carriers

Cisco IOS-XE Release 3.18.0S

This feature was introduced on the Cisco cBR Series Converged Broadband Routers.