Interface and Hardware Components Configuration Guide, Cisco Catalyst IE3x00 Rugged, IE3400 Heavy Duty, and ESS3300 Series Switches

PDF

Interface and Hardware Components Configuration Guide, Cisco Catalyst IE3x00 Rugged, IE3400 Heavy Duty, and ESS3300 Series Switches

Configure LLDP characteristics

Want to summarize with AI?

Log in

Configure the frequency of LLDP updates, the amount of time to hold the information before discarding it, and the initialization delay time.


Configure LLDP characteristics to control the frequency of LLDP updates, set the amount of time devices retain information before discarding it, and adjust the initialization delay time. You can also select which LLDP TLVs to send or receive.

You can configure the frequency of LLDP updates, set the duration information is held before discarding, and adjust the initialization delay time. You can also select which LLDP TLVs to send or receive.

Note

Steps 3 through 7 are optional and can be performed in any order.

Procedure

1.

Use the enable command to access privileged EXEC mode.

Example:


Device> enable
2.

Use the configure terminal command to access global configuration mode.

Example:


Device# configure terminal
3.

(Optional) Use the LLDP holdtime seconds command to set how long receiving devices keep information from your device before removing it.

Example:


Device(config)# lldp holdtime 120

The range is 0 to 65535 seconds; the default is 120 seconds.

4.

(Optional) Use the LLDP reinit delay command to specify the delay time in seconds for LLDP to initialize on an interface.

Example:


Device(config)# lldp reinit 2

The range is 2 to 5 seconds; the default is 2 seconds.

5.

(Optional) Use the LLDP timer rate command to set the sending frequency of LLDP updates in seconds.

Example:


Device(config)# lldp timer 30

The range is 5 to 65534 seconds; the default is 30 seconds.

6.

(Optional) Use the interface interface-id command to enable LLDP on an interface. This command also places you in interface configuration mode.

Example:


Device(config)# interface 
gigabitethernet2/1
7.

(Optional) Use the LLDP tlv-select tlv command to specify the LLDP TLV to send or receive on an interface.

Example:


 Device(config-if)# lldp tlv-select inventory management
Note

To disable LLDP TLVs, use the no LLDP tlv-select tlv command.

8.

Use theend command to return to privileged EXEC mode.

Example:


Device(config-if)# end
9.

Use the show LLDP command to display the global LLDP configuration and status on the device.

Example:


Device# show lldp

(Optional) Use the copy running-config startup-config command to save your entries in the configuration file.

Example:


Device# copy running-config startup-config