Contents

Introduction

Prerequisites

Requirements

Components Used

Problem

Reason for the Failure

Solution

Introduction

This document describes one possible reason why the initial chat creation fails to the Create Task node.

Error seen:

Contributed by Bhushan Suresh - Cisco TAC Engineer

Prerequisites

Requirements

Cisco recommends that you have knowledge of these topics:

- Webex Contact Center (WxCC) 2.0

- Webex connectportal with Email flows configured

Components Used

The information in this document is based on these software versions:

- WxCC 2.0

The information in this document was created from the devices in a specific lab environment. All of the devices used in this document started with a cleared (default) configuration. If your network is live, ensure that you understand the potential impact of any command.

Problem

When you open the flow and enable Decrypted debug logs, the error value is mandatory , name : origin is seen at the Create Task node:

Error Description:

status : 4002 , desc : value is mandatory , name : origin [ id : 3f5a23f9-6770-84c5-c9ea-8baa649950ce]

Reason for the Failure

The issue resides in the Origin field. Double-click theCreate Task node and check these 3 fields:

Access the variables passed on the Create Task node through Input Variables > Receive and check the Name and Email fields. This must MATCH the variables in the earlier image.

These two fields are set through the Chat template where the Name and the Email fields are mandatory.

Solution

Ensure the Name and Email parameters have the Name set to Name and Email:

If you would like to have the field Name and Email fields named differently, (Email parameter is named as eMail and not Email)

.

Please ensure the fields are updated the same on the Create Task node or the Create Task for the chat fails.