Does the Codian ISDN GW support downspeeding?

Available Languages

Updated:April 23, 2015
Document ID:112322

Bias-Free Language

The documentation set for this product strives to use bias-free language. For the purposes of this documentation set, bias-free is defined as language that does not imply discrimination based on age, disability, gender, racial identity, ethnic identity, sexual orientation, socioeconomic status, and intersectionality. Exceptions may be present in the documentation due to language that is hardcoded in the user interfaces of the product software, language used based on RFP documentation, or language that is used by a referenced third-party product. Learn more about how Cisco is using Inclusive Language.

Introduction

This article relates to the Cisco TelePresence ISDN GW 3241 and Cisco TelePresence ISDN GW MSE 8321 products.

Q. Does the Codian ISDN GW support downspeeding?

A. Yes, if a channel (other than the primary channel) is dropped, the call should be renegotiated at a lower bit rate using less BRIs. If the primary channel drops, then the call will fail.

For downspeeding to work:

  • The endpoint must support it

  • The call must be a Bonded call

Note: A number of interoperability issues may occur between the Codian ISDN GW and an endpoint while downspeeding. Contact the technical support team to check if the Codian ISDN GW supports downspeeding with your endpoint.

Related Information

Revision History

Revision Publish Date Comments
1.0
23-Apr-2015
Initial Release

Was this Document Helpful?

FeedbackFeedback

Contact Cisco