Quality of Service (QoS) Properties on ESW2-350G Switches

Objective

Quality of Service (QoS) is mainly used to improve the network performance and is used to provide the desired services for the users. It prioritizes the traffic flow based on the type of traffic. QoS can be applied to prioritize traffic for latency-sensitive applications (such as voice or video) and to control the impact of latency-insensitive traffic (such as bulk data transfers).

This article explains how to configure QoS properties on ESW2-350G Switches.

Applicable Devices

• ESW2-350G
• ESW2-350G-DC

Software Version

• 1.3.0.62

QoS Properties

QoS Mode

Step 1. Log in to the web configuration utility and choose Quality of Service > General > QoS Properties. The QoS Properties page opens.

Step 2. From the QoS Mode area choose a QoS mode. The possible modes are:

• Disable — QoS is disabled in the device. In this mode there is no priority of traffic.

• Basic — QoS is enabled on the device in the Basic mode. Basic mode is the mode where all the traffic of same class receives the same treatment. Action is taken based on the QoS value of the incoming frame. This QoS value determines the traffic class and QoS.

• Advanced — QoS is enabled on the device in the Advanced mode. Advanced mode is the mode which operates by per flow QoS service. It consists of class map and policer. Class map tells about the kind of traffic which is present in the flow and it also consists of few ACL's. The packets that match the ACL belong to one flow. The policer applies the configured QoS to the flow.

Step 3. Click Apply.

QoS on Interfaces

Step 1. Log in to the web configuration utility and choose Quality of Service > General > QoS Properties. The QoS Properties page opens.

Step 2. From the Filter: Interface Type drop-down list choose either Port or LAG. Port refers to a single interface whereas LAG refers to a bundle of interfaces.

Step 3. Click Go to bring up list of all ports or LAGs.

Step 4. Click Apply.

Step 5. To edit the properties of a specific interface, check the check box of the appropriate interface.

Step 6. Scroll down the page and click Edit. A new window appears:

Step 7. (Optional) In the Interface field click either Port if you want to specify QoS properties to a specific interface or click LAG if you want to specify QoS properties on a bunch of individual ports. From the adjacent drop-down list choose the desired interface.

Step 8. From the Default CoS drop-down list choose the required CoS value. Class of Service is used to group similar kinds of traffic into a particular class which can then be served based on priorities.The range is from 0 to 7. 0 is for the lowest priority and 7 is for the highest priority.

Step 9. Click Apply to save the settings.

Copy and Restore CoS Settings

Step 1. Log in to the web configuration utility and choose Quality of Service > General > QoS Properties. Scroll down the QoS Properties page.

 Step 2. To copy the QoS properties of an interface to another or multiple interfaces check the check box of the source interface and click Copy Settings. A new window appears:

Step 3. In the provided field enter the destination interface. You can enter interface numbers, names of interfaces, or ranges of interfaces.

Step 4. Click Apply to save the changes.

Step 5. (Optional) Click Restore Defaults if you want to restore the default QoS properties on the interfaces.