IPv4 Interface Configuration on ESW2-350G Switches

Available Languages

Download Options

PDF (1.0 MB)
View with Adobe Reader on a variety of devices
ePub (1.0 MB)
View in various apps on iPhone, iPad, Android, Sony Reader, or Windows Phone
Mobi (Kindle) (322.7 KB)
View on Kindle device or Kindle app on multiple devices

Updated:April 18, 2017

Document ID:SMB3740

Bias-Free Language

The documentation set for this product strives to use bias-free language. For the purposes of this documentation set, bias-free is defined as language that does not imply discrimination based on age, disability, gender, racial identity, ethnic identity, sexual orientation, socioeconomic status, and intersectionality. Exceptions may be present in the documentation due to language that is hardcoded in the user interfaces of the product software, language used based on RFP documentation, or language that is used by a referenced third-party product. Learn more about how Cisco is using Inclusive Language.

IPv4 Interface Configuration on ESW2-350G Switches

Objectives

This document explains how to configure the IPv4 interface statically or dynamically depending on the requirement. This helps the user to configure IPv4 addresses statically or dynamically on the ESW2-350G switch. If a switch doesn't have a DHCP server running then the IP address needs to be assigned statically.

Applicable Devices

• ESW2-350G
• ESW2-350G-DC

Software Version

• 1.3.0.62

Dynamic IPv4 Configuration

Step 1. Log in to the switch configuration utility and choose Administration > Management Interface > IPv4 Interface. The IPv4 Interface page opens:

Step 2. Choose the Management VLAN from the drop-down list. By default the management VLAN is 1.

Step 3. Click Dynamic in the IP Address Type field.

Step 4. (Optional) Check the Enable check box in the Renew IP Address Now field to renew the IP address at this instant.

Step 5. Click Apply.

Static IPv4 Configuration

Step 1. Log in to the switch configuration utility and choose Administration > Management Interface > IPv4 Interface. The IPv4 Interface page opens:

Step 2. Choose the Management VLAN from the drop down list. By default the management VLAN is 1.

Step 3. Click Static in the IP Address Type field.

Step 4. Enter the IP address for the IPv4 interface in the IP Address field.

Step 5. Choose the mask type from the Mask field.

• Network Mask — Enter the subnet mask of the IP address entered in Step 4.

• Prefix Length — Enter the prefix length of the IP address entered in Step 4.

Step 6. Choose the Administrative Default Gateway that is used to access the device for the switch web configuration utility.

• User Defined — Enter the desired default gateway IP address in the field.

• None — This option chooses not to have any default gateway IP address.

Note: When configuring IPv4 address statically, the Renew IP Address Now will not be active because a static IP cannot be assigned automatically. It must be entered manually.

Step 7. Click Apply.

User Account Management on ESW2-350G

Configure Idle Session Timeout on ESW2-350G

Password Strength