IP Mode on RV180 and RV180W
The Device supports IPv4 and IPv6 device networks on the LAN and Dedicated WAN.This article explains how to choose the mode on the RV180 and RV180W.
Steps of Procedure
Step 1. Use the router configuration utility to choose Networking > IPv6 > IP Mode. IP Mode page opens.
Step 2. Click the IP mode
• IPv4 Only — The LAN and WAN interfaces are members of an IPv4 network. This is the default setting.
• IPv4 and IPv6 Dual-Stack — If the LAN and Dedicated WAN interfaces are part of a dual (IPv4/IPv6) network.
Step 3. Click Save to apply changes.