PDF(121.5 KB) View with Adobe Reader on a variety of devices
ePub(162.1 KB) View in various apps on iPhone, iPad, Android, Sony Reader, or Windows Phone
Mobi (Kindle)(110.1 KB) View on Kindle device or Kindle app on multiple devices
Updated:December 10, 2018
The documentation set for this product strives to use bias-free language. For the purposes of this documentation set, bias-free is defined as language that does not imply discrimination based on age, disability, gender, racial identity, ethnic identity, sexual orientation, socioeconomic status, and intersectionality. Exceptions may be present in the documentation due to language that is hardcoded in the user interfaces of the product software, language used based on RFP documentation, or language that is used by a referenced third-party product. Learn more about how Cisco is using Inclusive Language.
Configuration of RADIUS Server on RV180 and RV180W routers
Remote Authentication Dial In User Service (RADIUS) is a client/server protocol that provides Authentication, Authorization, and Accounting (AAA) management for computers to connect and receive a network service.
The objective of this document is to explain how to enable and configure the RADIUS Server for RV180 and RV180W routers.
• RV180 • RV180W
Configuration of RADIUS Server
Step 1. Use the Configuration Utility to choose Security > RADIUS Server. The RADIUS Server page opens:
Step 2. In the RADIUS Server table, click Add. The Add/Edit RADIUS Server Configuration page opens:
Step 3. Fill in the following information.
• Authentication Server IP Address — The IP address of the authenticating RADIUS Server.
• Authentication Port — The RADIUS Authentication server's port number that is used to send RADIUS traffic. Its value ranges from 0 - 65535. The default value is 1812.
• Secret — The shared key that allows the device to authenticate with the RADIUS Server. The key must match the key configured on the RADIUS Server itself. Secret can contain all characters except for single quote ('), double quote (") and space ( ).
• Timeout — The timeout interval (in seconds) after which the device re-authenticates with the RADIUS Server. The value ranges from 1 - 999. The default value is 30.
• Retries — The number of retries for the device to re-authenticate with the RADIUS Server. The value ranges from 1 - 999. The default value is 4.
Step 4. Click Save to submit changes.
Step 5. Click Back to go back to the RADIUS Server display page under Security menu. The RADIUS Server table displays the entries. From here, additional servers can be added or existing servers can be edited or deleted.