Explore Cisco
How to Buy

Have an account?

  •   Personalized content
  •   Your products and support

Need an account?

Create an account

How can I verify what firmware version my disks are running on?

Available Languages

Updated:July 15, 2014
Document ID:117947

Bias-Free Language

The documentation set for this product strives to use bias-free language. For the purposes of this documentation set, bias-free is defined as language that does not imply discrimination based on age, disability, gender, racial identity, ethnic identity, sexual orientation, socioeconomic status, and intersectionality. Exceptions may be present in the documentation due to language that is hardcoded in the user interfaces of the product software, language used based on RFP documentation, or language that is used by a referenced third-party product. Learn more about how Cisco is using Inclusive Language.

Contents

Question

How can I verify what firmware version my disks are running on?

Symptoms:  On the WSA 'diagnostic -> raid' does not work.

Environment: Cisco Web Security Appliance (WSA), all versions of AsyncOS

Use the CLI command 'ipcheck' on the WSA to check your disk firmware. This command should show the firmware version of the disks used on WSA.

If you see:Disk x: 136GB MAXTOR ATLAS10K5_147SASBP00J496ZJRK (BP00 being key) you must upgrade your firmware.

If you see a string that contains "BP05," then the disk is already running the patched firmware. No further action is required.

TAC Authored

Contributed by Cisco Engineers

  • Jakob Dohrmann and Siddharth Rajpathak
    Cisco TAC Engineers.

Was this Document Helpful?

FeedbackFeedback

Contact Cisco

This Document Applies to These Products