Contents

Introduction

Prerequisites

Requirements

Components Used

Configure

Configuration on Azure

Configuration in Secure Access

Verify

Related Information

Introduction

This document describes the integration of Data Loss Prevention for Office 365 with Secure Access.

Prerequisites

- Office 365 E3 Subscription is present for your Microsoft tenant

- Compliance auditing is configured as ON in the compliance portal before you start your integration

Requirements

Cisco recommends that you have knowledge of these topics:

- Cisco Secure Access

- Microsoft Azure Enterprise Applications and App Registrations

Components Used

The information in this document is based on these software and hardware versions:

- Cisco Secure Access

- Microsoft Azure

- Microsoft 365 Compliance portal

The information in this document was created from the devices in a specific lab environment. All of the devices used in this document started with a cleared (default) configuration. If your network is live, ensure that you understand the potential impact of any command.

Configure

Configuration on Azure

To enable the application on Azure, configure according to the next steps:

1. Navigate to the Azure Portal > Enterprise Applications > New Application.

2. Click on Create your own Application.

3. Give a name you desire to identify the app and choose. Integrate any other application you don't find in the gallery (Non-Gallery).

4. Once done, use the Azure Search Bar to look for App Registrations.

5. Click on All Applications and choose the application created in step Three.

6. Choose API Permissions.

7. Click on Add a permission and choose the required permissions based on the Table.

Note: For that, you must configure the API of Microsoft Graph, Office 365 Management APIs, and SharePoint.

Note: Instead of  Site.FullControl.All permission choose Sites.FullControl.All.

- For that, you need to choose the permission based on the application and type:

8. Once all the required permissions are added, click on Grant Admin Consent for the tenant.

- Once you grant the permissions, the status is visible as Granted

Now that the configuration on Azure is completed, you can continue the configuration on Secure Access.

Configuration in Secure Access

To enable the integration, configure according the next steps:

1. Navigate to Admin > Authentication.

2. Under Platforms, clickMicrosoft 365.

3. Click Authorize New Tenant  in the DLP subsection and add Microsoft 365.

4. In the Microsoft 365 Authorization dialog, check the checkboxes to verify you meet the prerequisites, then click Next.

5. Provide a name for your tenant, then click Next.

6. Click Next to be redirected to the Microsoft 365 login page.

7. Log in to Microsoft 365 with admin credentials to grant access. Then, when you get redirected to Secure Access, you must have a message that indicates your integration was successful.

8. Click Done to complete.

Verify

To verify if the integration was successful, navigate to your Secure Access Dashboard:

- Click on Admin > Authentication > Microsoft 365

And if everything is correctly configured, your status must be Authorized.

Related Information

- Enable SaaS API Data Loss Protection for Microsoft 365 Tenants

- Turning auditing ON or OFF in Microsoft