IP Address and Port Show Up as 0.0.0.0:0 in IPS Signature Events

Available Languages

Updated:February 10, 2015
Document ID:118685

Bias-Free Language

The documentation set for this product strives to use bias-free language. For the purposes of this documentation set, bias-free is defined as language that does not imply discrimination based on age, disability, gender, racial identity, ethnic identity, sexual orientation, socioeconomic status, and intersectionality. Exceptions may be present in the documentation due to language that is hardcoded in the user interfaces of the product software, language used based on RFP documentation, or language that is used by a referenced third-party product. Learn more about how Cisco is using Inclusive Language.

Introduction

This document explains what Intrusion Prevention System (IPS) Event Summarization is and what the reasons are for IP addresses that show up as 0.0.0.0:0 in IPS signature events.

View Full Documentlogin required

Additional entitlement is required to view the full document.

Most of our content is available to the public. This document contains sensitive information and is available only to partners and customers with a valid service contract.

Learn more about Cisco Service Contracts

TAC Authored

Contributed by Cisco Engineers

  • Akhil B
    Cisco TAC Engineer
  • Prapanch Ramamoorthy
    Cisco TAC Engineer
  • Thulasi Shankar
    Cisco TAC Engineer

Was this Document Helpful?

FeedbackFeedback

Contact Cisco

This Document Applies to These Products