Contents

Introduction

Steps to perform filesystem checks

Introduction

This document describes the steps needed to perform File System check on the Cyber Vision Center server. It’s applicable to the 4.x software trains.

Steps to perform filesystem checks

1. Reboot the Center server and boot it in rescue mode, by pressing TAB when you see the following text:

2. Then the following boot menu appears:

3. Type the command ‘SBS-factory’ as shown above

4. Enter the username and password.

Username: root

Password: sentryo69!

5. Unmount the file system

cd /

umount -f /dev/disk/by-label/SBS-Data

6. Run the fsck command

fsck.ext4 -v -f -y /dev/disk/by-label/SBS-Data

The final output will look similar to this depending on the file system in the deployment

If the server continues to report errors, open a TAC service request for further diagnosis.