Contents

Introduction

Prerequisites

Requirements

Components Used

Scope

Considerations

Sign Certificate

Scenario 1. Certificate for New Controller

Scenario 2. Renew Certificate for Controller

Related Information

Introduction

This document describes the procedure to sign Software Defined Wide Area Network (SD-WAN) certificates with manual option.

Prerequisites

Requirements

Cisco recommends that you have knowledge of these topics:

- Cisco Software-defined Wide Area Network (SD-WAN)

- Cisco SD-WAN vManage

Components Used

This document is based on this SD-WAN device and portal:

- vManage Controller

- Plug and Play Portal (PnP)

The information in this document was created from the devices in a specific lab environment. All of the devices used in this document started with a cleared (default) configuration. If your network is live, ensure that you understand the potential impact of any command.

Scope

- This procedure is used when vManage has no connectivity to the Internet.

- You can use this process to sign Certificate Signed Request (CSR) for new controllers or renew certificates.

Considerations

- The basic configuration is applied to the controllers

- Controllers have connectivity between them

If you need information about Controller Deployment, navigate to Cisco SD-WAN Overlay Network Bring-Up Process.

Please visit Certificate Management if you are interested in other ways of controller SD-WAN certification.

Sign Certificate

Scenario 1. Certificate for New Controller

Step 1. Log in to vManage.

Step 2. Navigate to  Main Menu > Configuration > Devices > Controller > Add Controller.

Selection for controller

Step 3. Fill in the controller information and check  Generate CSR  box as shown in this image.

Controller Information

Step 4. Download CSR file from  Main Menu > Configuration > Certificates > Controllers > Three dots > View CSR.

Certificate request

Step 5. Log into PnP Portal.

Step 6. Navigate to  Main Menu > Certificates > + Generate Certificate.

Plug and Play portal certificate

Step 7. Fill in certificate information, then click Next and finally Submit.

Certificate information

Step 8. Download Certificate Signed.

Step 9. Navigate to  Main Menu > Configuration > Devices > Controllers > Install Certificate.

Certificate controller

Step 10. Wait for a bit while the certificate is sent to the controller. Once it is done, you see this:

Certificate installation

Scenario 2. Renew Certificate for Controller

Step 1. Log in to vManage.

Step 2. Navigate to  Main Menu > Configuration > Certificates > Controller > Three Dots > Generate CSR.

CSR generate

Step 3. Once you downlaod the CSR, perform Step 5. to Step 10. from the Scenario 1.

Related Information

- Cisco SD-WAN Getting Started Guide

- Technical Support & Documentation - Cisco Systems