Contents

Introduction

Prerequisites

Adding a Device to a Cisco Account in LRP

Troubleshooting

Related Information

Introduction

This article describes the process of adding a device to a Cisco account in License Registration Portal (LRP).

Prerequisites

Before you start, ensure that you have the following:

- Active Cisco.com account

- Universal Device Identifier (UDI)

Adding a Device to a Cisco Account in LRP

Step 1:

Go to Cisco Software Central and log in with your Cisco.com account.

Step 2:

In the Traditional Licenses section, click Access LRP.

Step 3:

On the Devices tab, click Add Devices.

Note: If the system displays the Welcome To The License Registration Portal alert dialog box, you can select Do not show this message again to prevent it from being displayed again.

Step 4:

In the Add Device dialog box, from the Product Family drop-down list, select the correct Product Family. Enter the relevant Device Identifier. Click OK.

Step result: The system displays the Device Added Successfully notification message.

Note: The information requested on the Add Device tab varies depending on a product for which you issue the license key. To obtain the product-specific information that the system requests in the Add Device dialog box, refer to How to Locate the Universal Device Identifier (UDI).

Troubleshooting

If you experience an issue during the process of adding a device to a Cisco account in LRP, open a case inSupport Case Manager (SCM).

Related Information

How to Move ASA Firepower Classic Licenses

How to Move CUCM Classic Licenses

How to Move ISE Classic Licenses