Telepresence FAQ: Which MSE 8000 blades can be used in a blade cluster?

Available Languages

Updated:September 3, 2014
Document ID:118346

Bias-Free Language

The documentation set for this product strives to use bias-free language. For the purposes of this documentation set, bias-free is defined as language that does not imply discrimination based on age, disability, gender, racial identity, ethnic identity, sexual orientation, socioeconomic status, and intersectionality. Exceptions may be present in the documentation due to language that is hardcoded in the user interfaces of the product software, language used based on RFP documentation, or language that is used by a referenced third-party product. Learn more about how Cisco is using Inclusive Language.

Introduction

This document describes which blades can be clustered in the Cisco TelePresence Mobility Service Engine (MSE) 8000 chassis.

Which MSE 8000 blades can be used in the blade cluster?

You can cluster up to three MSE 8510 blades, if they all run Multipoint Control Unit (MCU) Version 4.1 or later. You can cluster up to three MSE 8710 blades, if they all run TelePresence Server Version 2.1, or up to four blades if they all run Version 2.2. You can house more than one cluster in a chassis, alongside standalone blades or other clusters, provided that you do not use slot 10 for any clustered blade. The Cisco TelePresence Supervisor MSE 8050 blade must be in slot one and the other nine slots can be used for any other types of MSE 8000 blades.

Tip: See "Understanding Clustering" in the online help for more information.

Revision History

Revision Publish Date Comments
1.0
03-Sep-2014
Initial Release
TAC Authored

Contributed by Cisco Engineers

Was this Document Helpful?

FeedbackFeedback

Contact Cisco

This Document Applies to These Products