TANDBERG Codec - Why won't DVI-I to DVI-I connection work?

Available Languages

Updated:April 23, 2015

Document ID:112651

Bias-Free Language

The documentation set for this product strives to use bias-free language. For the purposes of this documentation set, bias-free is defined as language that does not imply discrimination based on age, disability, gender, racial identity, ethnic identity, sexual orientation, socioeconomic status, and intersectionality. Exceptions may be present in the documentation due to language that is hardcoded in the user interfaces of the product software, language used based on RFP documentation, or language that is used by a referenced third-party product. Learn more about how Cisco is using Inclusive Language.

Introduction

I can't get a DVI-I to DVI-I connection to work for my TANDBERG Codec, why?

Related Information

Introduction

This article relates to the Cisco TelePresence System Codec C90 and Cisco TelePresence System Codec C60 products.

Q. I can't get a DVI-I to DVI-I connection to work for my TANDBERG Codec, why?

A. The below information is only valid for software versions lower than TC2.0.0.

This answer is valid for the following products:

TANDBERG Codec C60

TANDBERG Codec C90

Currently, the TANDBERG Codec C90 does not work reliably with a DVI-I to DVI-I cable. Use a DVI-I to DVI-A, or a DVI-I to DVI-D cable instead.