This article relates to the Cisco TelePresence System Codec C90, Cisco TelePresence System Codec C60 and Cisco TelePresence System Codec C40 products.
Q. Are there any shortcuts on the TANDBERG Codec remote control?
A. This answer is valid for the following products:
TANDBERG Codec C20
TANDBERG Codec C40
TANDBERG Codec C60
TANDBERG Codec C90
The following remote control shortcuts are available:
Home menu: Press the ok / V key when no menus are shown (same as pressing the home key in any menu)
System Information and Call status : Press the right-most function key on the home menu.
Advanced Configuration: Press the fourth function key (from left) on the System Information and Call status page. The quick key sequence is "home- right-most function key - fourth function key" (or "V- right-most function key - fourth function key" when no menus are shown)
Call menu: Press any number key in idle mode (when not in a call).
Recent calls: Press the call key when the Call menu is not visible
Dial last number: Press the call key twice
Standby mode: Press and hold the disconnect key for 5 seconds
Restore resolution and OSD: When not in a call, press the sequence "disconnect - * - # - * - # - 0 - x - #" where x is output 1 to 4 to change the OSD and restore the resolution (1280x720@60Hz for HDMI and 1024x768@60Hz for DVI) to the selected output
DTMF: Pressing a number key in a call gives the DTMF (Dual Tone Multiple Frequencies) sound for the pressed number