Tidal Enterprise Scheduler: JDE Unable to find FieldDescriptor for Error in the ClassDescriptor of action Error Message

Available Languages

Updated:January 30, 2012
Document ID:113319

Bias-Free Language

The documentation set for this product strives to use bias-free language. For the purposes of this documentation set, bias-free is defined as language that does not imply discrimination based on age, disability, gender, racial identity, ethnic identity, sexual orientation, socioeconomic status, and intersectionality. Exceptions may be present in the documentation due to language that is hardcoded in the user interfaces of the product software, language used based on RFP documentation, or language that is used by a referenced third-party product. Learn more about how Cisco is using Inclusive Language.

Introduction

This document provides information on how to resolve this JDE adapter connection error. This error appears in the client when you test the connection and is also found in the adapter service log.

Development JDE connect: unable to find FieldDescriptor for 'Error' in ClassDescriptor of
action
05/25 10:00:43:005[13:MD-3]: (mem=8851136/23339008) Development JDE connectInstance:
Connection failed, unable to find FieldDescriptor for 'Error' in ClassDescriptor of action

Prerequisites

Requirements

Cisco recommends that you have knowledge of these topics:

  • Cisco Tidal Enterprise Scheduler 5.3.1+

  • Cisco Tidal JDE Adapter

Components Used

The information in this document is based on these software and hardware versions:

  • Cisco Tidal Enterprise Scheduler 5.3.1+

  • Cisco Tidal JDE Adapter

The information in this document was created from the devices in a specific lab environment. All of the devices used in this document started with a cleared (default) configuration. If your network is live, make sure that you understand the potential impact of any command.

Conventions

Refer to Cisco Technical Tips Conventions for more information on document conventions.

Resolve the “Unable to find FieldDescriptor for ‘Error’ in the ClassDescriptor of action”Error

This is an issue related to configuration of the jde.ini on the JDE server. It is related to the LRENGINE section System parameter. Be sure that the directory exists for this parameter. If it does not exist, you can create the directory. Here is an example of an excerpt of jde.ini:

[LRENGINE]

System=/E900SYS/output

Repository_Size=20

Disk_Monitor=YES

Related Information

Was this Document Helpful?

FeedbackFeedback

Contact Cisco