Cisco Learning Labs for CCNP ROUTE lab topologies

Discovery 1: Configuring RIPng

Back to the top

Discovery 2: Configuring and Investigating Basic EIGRP

Back to the top

Discovery 3: Building the EIGRP Topology Table

Back to the top

Discovery 4: EIGRP Stub Routing

Back to the top

Discovery 5: EIGRP Summarization

Back to the top

Discovery 6: EIGRP Load Balancing

Back to the top

Discovery 7: EIGRP for IPv6 Configuration

Back to the top

Discovery 8: Discovering the Named EIGRP Configuration

Back to the top

Discovery 9: Basic OSPF Configuration Introduction

Back to the top

Discovery 10: Building the Link-State Database

Back to the top

Discovery 11: OSPF Path Selection

Back to the top

Discovery 12: OSPF Route Summarization

Back to the top

Discovery 13: OSPF Stub Areas

Back to the top

Discovery 14: Implementing OSPFv3

Back to the top

Discovery 15: Basic Redistribution

Back to the top

Discovery 16: Manipulate Redistribution

Back to the top

Discovery 17: Manipulate Redistribution Using Route Maps

Back to the top

Discovery 18: Analyzing Cisco Express Forwarding

Back to the top

Discovery 19: Implementing PBR

Back to the top

Discovery 20: Configuring NAT Virtual Interface

Back to the top

Discovery 21: Basic IPv6 Internet Connectivity

Back to the top

Discovery 22: Basic BGP Configuration

Back to the top

Discovery 23: Influencing BGP Path Selection

Back to the top

Discovery 24: BGP for IPv6

Back to the top

Discovery 25: Configuring EIGRP Authentication

Back to the top

Discovery 26: OSPF Authentication Configuration

Back to the top

Challenge 1: Configure RIPng

Back to the top

Challenge 2: Configure EIGRP

Back to the top

Challenge 3: Configure and Optimize EIGRP for IPv6

Back to the top

Challenge 4: Implement EIGRP for IPv4 and IPv6 Through Named Configuration

Back to the top

Challenge 5: Configure OSPF

Back to the top

Challenge 6: Optimize OSPF

Back to the top

Challenge 7: Configure OSPFv3

Back to the top

Challenge 8: Implement Redistribution Using Route Filtering

Back to the top

Challenge 9: Implement Path Control

Back to the top

Challenge 10: Configure BGP

Back to the top

Challenge 11: Configure Authentication for EIGRP Routes

Back to the top

Challenge 12: Configure BGP Authentication

Back to the top