SNMPv3 Targets

The SNMPv3 targets send SNMP notifications using Inform messages to the SNMP manager. For SNMPv3 targets, only the Informs are sent, not traps. For SNMP versions 1 and 2, the traps are sent. Each target is defined with a target IP address, UDP port, and SNMPv3 user name.

Note	The SNMPv3 user configuration (see the SNMPv3 Users page) should be completed before configuring the SNMPv3 targets. The WAP device supports a maximum of eight targets.

To add SNMP targets follow these steps:

Procedure

Step 1

Select Management> SNMPv3 Targets.

Step 2

Click ✚ to add a new row to the table.

Step 3

Check the check box in the new row and configure the following parameters:

IP Address — Enter the IPv4 or IPv6 address of the remote SNMP manager to receive the target.
UDP Port — Enter the UDP port to use for sending SNMPv3 targets.
Users — Enter the name of the SNMP user to associate with the target. To configure SNMP users, see the SNMPv3 Users page.

Step 4

Click Save. The user is added to the SNMPv3 Targets list and your changes are saved to the Startup Configuration.

Note	To remove a SMMP target, select the user in the list and click Delete. To edit a SMMP target, select the user in the list and click Edit.